The brake pads are generally composed of a steel plate, a bonded heat insulating layer and a friction block. The materials for manufacturing brake friction blocks can be divided into: asbestos brake pads, semi-metal brak...
It depends on whether the types of front and rear brake pads used in the car are the same. There are two types of brakes used in general cars. One is a disc brake and the other is a drum brake. There are more disc brakes...
A asbestos type brake pad (replaced for NAO type due to carcinogenic risk) B Non-asbestos friction materials are divided into the following categories: (a) Semi-metallic friction materials for disc brake pads for passeng...
When the following four conditions occur, the brake pads should be replaced in time: 1. When the thickness of the brake pads is less than the minimum maintenance standard allowed by the vehicle manufacturer. 2. When the ...
Analysis of the cause of abnormal noise during car steering and suggested solutions: 1. The friction steering wheel between the plastic parts is composed of various plastic parts. If the gap is too small when rotating, t...
The reasons for the failure of the lifting brake device and the corresponding treatment methods are as follows: 1. The seal inside the large chuck is aging failure, decompose the large chuck, check whether the seal ring ...
